Corsair FRAME 5000D RS High-Airflow Mid-Tower PC Case review

The FRAME 5000D RS is a mid-tower aimed at airflow. It has a steel front panel with a 3D-Y mesh pattern, four RS140 PWM fans in the box and room for large radiators. It takes Mini-ITX, Micro-ATX, ATX and E-ATX (305 x 277 mm) boards. It also supports ASUS BTF, MSI Project Zero and Gigabyte Project Stealth reverse-connector boards.

KitGuru says Corsair designed it slightly longer and wider than most other mid-tower cases. That size lines up with the board and radiator support.

Corsair says the 3D-Y front pattern increases airflow by 12.7% over the earlier tri-hex pattern. That is a manufacturer figure, but reviewers back up the general picture. TweakTown, Hardware Asylum, Overclocking.com and KitGuru all praise the cooling and airflow.

TweakTown gives numbers. At roughly 29°C ambient, with three front intakes and one rear exhaust, a Ryzen 9600X reached a maximum of 82°C and averaged 79°C. The GPU peaked at 74°C. The room was warm for that run, so read the figures with that in mind.

Radiator support is wide. The front takes 360, 280 or 240 mm. The top takes 420, 360, 280 or 240 mm. The side takes 360, 280 or 240 mm, and the rear takes a 120 or 140 mm unit. The bottom has no radiator mount.

Dust filters sit at the front, side and bottom. Owners point out that the top has no dust filter. With big top radiators supported, that is the gap to plan around.

Owners describe the modular layout as easy to build in. Fan mounts use Corsair's InfiniRail system with QuikTurn screws for fans. Rear cable routing space is 42 mm. The panels are steel and tempered glass.

Storage is 2x 3.5-inch HDD and 6x 2.5-inch SSD. The PSU must be ATX, is not included, and has 250 mm of clearance.

The maximum graphics card length is 450 mm, or 425 mm with front fans installed. Anyone fitting a very long card alongside front intake fans should check against the lower figure. CPU cooler height tops out at 175 mm.

With 360 mm radiator mounts on the front, top and side, plus 420 mm at the top, the case suits a liquid-cooled build. E-ATX support also helps large workstation-style boards. The six 2.5-inch SSD positions and two 3.5-inch bays cover a modest storage set-up.

Owners report that the included fans get loud at high speed, though they say fan curves help. The case ships with four PWM fans and no controller, so speed management comes from your own setup.

Owners also mention gaps in dust and sound insulation. That follows from a design that puts airflow first. A buyer who wants a quiet build should weigh this more heavily than the cooling praise.

This case suits a performance build with a hot CPU, a long GPU or a large radiator. It comes with four RS140 PWM fans, and TweakTown ran it with three at the front and one at the rear. TweakTown also says Corsair kept pricing in line with its competitors and scores value at 90%.

It is less suited to quiet-first builds or to anyone who wants a filter over every opening. The loud fans at high speed, the sound insulation gaps and the unfiltered top are the points to weigh against its cooling and building strengths.